Heliformed Line Fitting

• 
• Heliformed dead end clampDead ends on 110KV for ACSR conductor
  Dead ends on 10KV for ACSR conductor
  Dead ends on 10KV for AAC conductor ...

• 
• Heliformed suspension clampFor the reduction of static stresses at conductor suspension points and to provide greater protection to conductors against the dynamic stresses of Aeolian vibration.
  To give conductors protection against impulse and flash-over...

• 
• Heliformed armor rod The repaired armor rod was use for Repair of damaged distribution line phase and neutral conductors.
  Damage to distribution line phase and neutral conductor can occur in service for a number of reasons, including:
  Aeolian vibration and galloping...

• 
• Heliformed line splice It was use for Jointing and restorative repair on conductors of aluminum, Aluminum Coated Steel and galvanized steel.
  Conductivity
  In all cases - aluminum alloy, Aluminum Coated Steel and galvanized steel - Line Splices will...

• 
• Heliformed repair rod Sub-Sets: Individual rods assembled into groups of two, three, or four.
  And the products surface was Sand Blasting Surface Treatment. Core Splice: Galvanized steel, sub-setted and gritted. Need Sand Blasting Surface Treatment...

• 
• Heliformed damplerDamping devices are designed for the single purpose of reducing vibration. This single function is entirely different from that of protecting against (1) stress concentrations, (2) fretting or abrasion, and (3) arc-over burning. Because of this, damping devices should be considered only as supplemental to Armor Rod or other ...

• 
• Optic Line Fitting Heavy-Duty-Type Cable Thimbles,if used,can collapse when guy tensions are high.If thimbles are used in the loop of the GUY-GRIP dead-end,a large pin is recom-mended to fill the loop of the thimble to preventdistortion.The collapsing strength of the thimble and the proper pinsize should be obtained from the thimble manufacturer....